I have to find how to reduce the power of the pop bumpers, I think they are just going a bit too rough.
In the options there is a solenoid strength item, but it hasn't seem to effect the pop bumpers when I brought it from 12 to 4 or so. But it does seem to let the flippers be better? I'm not sure, I will have to play more.
Capcom flippers aren't super awesome, mostly because they have no EOS (end-of-stroke) and instead rely on circuiry. They couldn't catch balls with much reliability, sometimes losing their strength.
Flippers have an initial stroke at high voltage to kick the flipper upwards, and then a lesser voltage stroke to hold the flipper in place. On Break Shot it wasn't holding so well when a high-velocity ball came at it, but that seems different now that the solenoid option has changed. Maybe it was overcharged?
But still, the pop-bumpers seem too strong, especially since they don't really DO much of anything in this game. So to add to the list:
10) modify strength of pop bumpers, if possible
Remember that dead right inline switch? Yeah well turns out the switch is fine, just misaligned. I press down hard with my finger, made it click, and it registered fine. I can't believe I didn't think to troubleshoot it fully before!!!!
So now I have a backup rollover switch for it, because after bending the switch on the PF to be a bit more pronounced, it works fine. Yay! Well, as it turns out it doesn't actually DO much in regards to game play, but it makes a sound when the ball goes over... so... yay?
oh inline switch, if only you were USEFUL as well! |
I remembered a video from TNT Amusements that the giant capacitors in the Capcom games posed issues with their sheer girth, and they recommended binding them. So I attached a zip-tie around each pair, as precaution.
my capacitance brings all the boys to the yard |
In testing the switches, I realized something important: The left slingshot was WEAK. It was barely having an impact on ball travel beyond the rubber bounce.
I took a look, and found it was out of whack. It is a bit bent, but can probably be appropriately realigned. We shall see.
Rear view of left slingshot. We see it is sitting at the back of the slot, most likely bent by impacts. |
For comparison, the right slingshot is effective, and rest far off the back wall. |
11) correct left slingshot.
Oh and the flipper position needs adjustment. See future post.
12) adjust flipper position to the dots
so this calls for a list update:
4) level the legs (not pressing)
6b) replace/fix latch on center post locking mechanism (will order replacement just in case)
7) replace beer seal
9) install replacement rubbers we received
10) reduce strength of pop bumpers, if possible
11) correct left slingshot.
12) adjust flipper position to the dots
No comments:
Post a Comment