updating the todo lists...

ROCKY & BULLWINKLE

STUFF TO DO
adjust flippers to the dots
try troubleshooting audio connections: excessive hum + hum sound oscillating with light show
replacing the SAVED decals.
find a replacement WABAC ramp.
get/install a Boris button
deep disassemble-everything clean

DONE
reconnect CN1 connector to increase reliability
install new levellers + casters, level the legs
wire Lion to 32 V instead of 50 V
replace the back box hat trick padding
Replace plastic Lion in hat trick
replace ball drain kicker
Update ROMs to 1.3
remove pop bumper screw.
repair first left orbit (hat trick) switch so that the diverter can work
CLEAN ALL THE THINGS.
replace beer seal


STREET FIGHTER 2

TODO
verify ratings of all fuses
left VUK: get new spring, new plunger
replace stargate ramp coils
deep clean of playfield, removing all plastics and cleaning the screws
replace upper left flipper solenoid with correct one  (should be A-25959) (have it, no reason to do it yet though)
cleaning the under-playfield troughs
firmly attaching the coin door
replace playfield glass
replace all playfield rubbers (have a rubber set)
get cliffy protectors
replace 3 Gottlieb flipper bats (have them)
Replace car crash flipper rubber + glue car to crash mechanism
reattach subwoofer
fix 2 out lights in backbox (wiring issue?)

DONE
installed new power module
replaced Q3 transistor to solve right slingshot issue
reattached ground wires
replaced VUK solenoid to correct one
replaced fuse for stargate ramps
reattach tilt mechanism
bend left playfield bracket back in to proper place
new beer seal
Flipper rubber for Chun Li
Replaced flipper rubbers (except car crash flipper)
Cleaned backbox charring + replaced dead + charred lightbulbs
initial basic playfield cleaning


BREAKSHOT

TODO
replace clip on left slingshot
replace upper-right flipper coil with replacement we have
replace/fix latch on center post locking mechanism

reduce strength of pop bumpers, if possible
level the legs (not pressing)
adjust flipper position to the dots
 
DONE
Add rubber casters to legs and drink holder to front right leg.
install the extra rubber pieces we received
Oiled upper right miniflipper.  Got it working, then learned you shouldn't do that.
Found out why machine freezes when at TILT:  was acting as an electromagnet
clean and wax
Fixed left outlane switch (adjusted height)
replace compression spring in center post.  discovered issue was more the ledge plate.
replaced beer seal
adjusted right inline switch so it registered